Gear Sensor/Switch: Testing and Inspection

NEUTRAL SWITCH INSPECTION [L3 WITH TC]

NOTE: Perform the following inspection only when directed.

Continuity Inspection

1. Disconnect the negative battery cable.
2. Remove the neutral switch.
3. Inspect for continuity between the neutral switch terminals using a tester.




- If the neutral switch is normal, but PID value is out of specification, perform the "Circuit Open/ Short Inspection".
- If not as specified, replace the neutral switch.

Circuit Open/Short Inspection

1. Disconnect the PCM connector.







2. Inspect the following harnesses for an open or short circuit. (Continuity check)

Open circuit
- If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
- Neutral switch terminal B and PCM terminal 1W
- Neutral switch terminal A and body ground

Short circuit
- If there is no continuity, there is a short circuit. Repair or replace the wiring harness.
- Neutral switch terminal B and body ground