DSC HU/CM Removal/Installation

DSC HU/CM REMOVAL/INSTALLATION





Caution:
^ When replacing the DSC HU/CM, configuration procedure must be done before removing the DSC HU/CM. If configuration is not completed before removing the DSC HU/CM, DTC B2477 will be detected.
^ The internal parts of the DSC HU/CM could be damaged if dropped. Be careful not to drop the DSC HU/CM. Replace the DSC HU/CM if it is subjected to an impact.

1. Configurate the DSC HU/CM (only when replacing it).
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Perform the initialization procedures for the combined sensor.

Connector Removal Note





1. Release the lock lever to unlock it.
2. Remove the connector

Brake Pipe Removal Note





1. Mark the brake pipe connecting positions before removal for reference during installation.

DSC HU/CM Removal/Installation Note
1. When removing/installing the DSC HU/CM from/to the vehicle, attach a strip of protective tape on the DSC HU/CM connector to prevent brake fluid from entering.

Brake Pipe Installation Note





1. When installing the brake pipe, align the marks made before removal with the DSC HU/CM as shown in the figure

Connector Installation Note





1. Verify that the lock lever of the harness connector is securely locked.